What size of water pump is needed for a 60 meter fish tank? What is the flow rate of the water pump used for a 60 meter fish tank?

『Calculation of flow rate of fish tank water pump』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)

What size fish tank is a 1.15W water pump suitable for? A 15W water pump is suitable for medium-sized fish tanks ranging from 120 to 240 liters, and specific matching needs to be based on flow parameters and feeding requirements.

1. Core Matching Principle 1. Flow Calculation Standard: It is recommended that the pump flow rate reach 5-10 times the total water volume of the fish tank per hour.

. The typical flow range of a 15W water pump is 1000-1500L/H (liters/hour). According to this calculation:

(1) 1000L/H ÷ 10=100 liters (minimum applicable)

(2) 1500L/H ÷ 5=300 liters (maximum applicable)

(3) In actual operation, taking the middle value of 120-240 liters is more reliable

2. The influence of feeding density

(1) For large fish such as goldfish and koi: choose the upper limit flow rate (10 times), such as a 240L tank that requires a flow rate of 1500L/H. (2) Small tropical fish: The lower limit flow rate (5-7 times) can be taken, and 1000L/H is sufficient for a 120 liter cylinder.

2. Key selection elements: 1. Head loss correction

(1) The nominal flow rate of the water pump is "zero head" data, and in actual use, about 15% of the flow rate is lost for every 1 meter increase in height.

. Example: A water pump with a nominal capacity of 1500L/H has an actual flow rate of approximately 1275L/H at a head of 1 meter. (2) Users of the bottom filter cylinder need to pay special attention to calculating the total height (main cylinder+bottom cabinet). (2) Adaptation of filter material types. (1) Biochemical cotton/ceramic ring: increase water flow resistance by 20-30%. (2) Activated carbon/fine filter bag: may lose more than 40% of the flow. It is recommended to reserve 15-20% of the flow margin to deal with filter material blockage. (1) Water grass cylinder: 500-800L/H flow is sufficient, strong water flow affects CO2 distribution. 2) Dragon fish tank: To create surface water flow, it is recommended to install a wave making pump as an auxiliary. (3) Sea water tank: Separate calculation from the egg separation pump to avoid system overload. (3) Operation precautions: 1. Noise control skills. (1) Suspend the water pump short and borrow it (use a suction cup hall to lift it up) to reduce resonance. (2) Regularly clean the algae accumulation on the rotor

(3) Reduce the flow rate by 30% at night to reduce noise. 2. Energy saving optimization plan

Shutdown inspection 2. Water quality monitoring correlation

(1) Ammonia nitrogen concentration>0.5mg/L: prompts to increase flow rate by 20%

(2) When the water is turbid: temporarily increase flow rate by 50% and rush filtration

(3) PH Large value fluctuation: Check if the dissolved oxygen is too low due to insufficient flow rate. 3. Backup system configuration: (1) Main pump power x 70%=minimum power of backup pump. (2) It is recommended to install a dual pump parallel interface, which can be quickly switched in case of failure. (3) UPS power supply can guarantee 4-6 hours of basic circulation during power outage. Summary operation suggestion: Measure the actual water volume (length x width x height x 0.85), prioritize the adjustable flow water pump, set it to 8 times the initial flow rate, and adjust it according to the fish status and water quality test results. For large cylinders with a capacity of 240 liters or more, it is recommended to upgrade directly to a water pump with a capacity of 25W or more.

2

『SILVER Official Website SERVICE』